eufy T2108 how to restart RoboVac with the main power switch
When RoboVac cannot be activated or stops working suddenly and the other checks in the troubleshooting table did not help.
Steps
- Turn off the main power switch on the bottom of RoboVac.
- Wait 2 seconds.
- Turn the main power switch back on.
Source: Troubleshooting: RoboVac stops working suddenly Source: Troubleshooting: RoboVac stops working suddenly, p. 23
Used for
- RoboVac cannot be activated
- RoboVac stops working suddenly
- RoboVac moves or travels in an abnormal path
Other T2108 procedures
- How to charge RoboVacBefore first use, after a four-beep low-power error, or when RoboVac does not dock by itself.
- How to clean the dust collector and filtersAfter each use for the dust collector and once a week for the filters.
- How to clean the rolling brushOnce a week, or when the rolling brush does not rotate or four beeps sound with a solid red light.
- How to clean the side brushesOnce a month, or after two beeps with a solid red light.
- How to replace the side brushesEvery 3 to 6 months, or when a side brush is bent, damaged or visibly worn.
- How to clean the sensors and charging pinsOnce a month, or when RoboVac cannot charge, cannot return to the Charging Base or moves abnormally.
- How to clean the swivel wheelOnce a month and as needed, when hair or dust is caught in the swivel wheel.
Sources
- Owner's Manual, RoboVac T2108/T2109/T2110. Anker Innovations Limited. Document 51005001324, revision V01, 28 pages, en. service.eufy.com. Listed on the manufacturer's support page. Retrieved 13 November 2026.
Page numbers are the numbers printed in the manual. Where this page and the manual differ, follow the manual.