eufy T2108 how to clean the swivel wheel
Once a month and as needed, when hair or dust is caught in the swivel wheel.
Steps
- Pull out the swivel wheel.
- Remove any hair or debris wrapped around the wheel or caught inside the wheel cavity.
- Push the wheel back in until it clicks into place. The wheel can be cleaned with water; use it only when completely dry.
Source: Cleaning and Maintenance: Clean the Swivel Wheel Source: Cleaning and Maintenance: Clean the Swivel Wheel, p. 22
Other T2108 procedures
- How to restart RoboVac with the main power switchWhen RoboVac cannot be activated or stops working suddenly and the other checks in the troubleshooting table did not help.
- How to charge RoboVacBefore first use, after a four-beep low-power error, or when RoboVac does not dock by itself.
- How to clean the dust collector and filtersAfter each use for the dust collector and once a week for the filters.
- How to clean the rolling brushOnce a week, or when the rolling brush does not rotate or four beeps sound with a solid red light.
- How to clean the side brushesOnce a month, or after two beeps with a solid red light.
- How to replace the side brushesEvery 3 to 6 months, or when a side brush is bent, damaged or visibly worn.
- How to clean the sensors and charging pinsOnce a month, or when RoboVac cannot charge, cannot return to the Charging Base or moves abnormally.
Sources
- Owner's Manual, RoboVac T2108/T2109/T2110. Anker Innovations Limited. Document 51005001324, revision V01, 28 pages, en. service.eufy.com. Listed on the manufacturer's support page. Retrieved 13 November 2026.
Page numbers are the numbers printed in the manual. Where this page and the manual differ, follow the manual.