eufy T2108 how to clean the dust collector and filters

After each use for the dust collector and once a week for the filters.

You need

Steps

  1. Press the dust collector release button and pull the dust collector out.
  2. Open and empty the dust collector.
  3. Pull the hooks to remove the pre-filter.
  4. Take out the foam filter and the high-performance filter.
  5. Clean the dust collector and filters with a vacuum cleaner or a cleaning brush. The dust collector, pre-filter and foam filter can also be washed with water; air-dry them thoroughly before reassembling. Do not wash the high-performance filter with water.
  6. Put the filters and the pre-filter back together in the dust collector.
  7. Push the dust collector back into the main unit.

Source: Cleaning and Maintenance: Clean the Dust Collector and Filters Source: Cleaning and Maintenance: Clean the Dust Collector and Filters, pp. 19-20

Used for

Other T2108 procedures

Sources

  1. Owner's Manual, RoboVac T2108/T2109/T2110. Anker Innovations Limited. Document 51005001324, revision V01, 28 pages, en. service.eufy.com. Listed on the manufacturer's support page. Retrieved 13 November 2026.

Page numbers are the numbers printed in the manual. Where this page and the manual differ, follow the manual.

Applies to
T2108, T2109, T2110. Worldwide.
Source
Owner's Manual, RoboVac T2108/T2109/T2110, 51005001324 revision V01
Last verified
Handbook
eufy RoboVac 11S robot vacuum in Robot vacuums; all eufy handbooks