eufy T2108 how to clean the sensors and charging pins
Once a month, or when RoboVac cannot charge, cannot return to the Charging Base or moves abnormally.
Steps
- Dust off the drop sensors on the bottom of RoboVac with a cloth or cleaning brush.
- Dust off the charging contact pins on RoboVac and on the Charging Base with a cloth or cleaning brush.
Source: Cleaning and Maintenance: Clean the Sensors and Charging Pins Source: Cleaning and Maintenance: Clean the Sensors and Charging Pins, p. 22
Used for
- RoboVac cannot be charged
- RoboVac cannot return to the Charging Base
- RoboVac moves or travels in an abnormal path
Other T2108 procedures
- How to restart RoboVac with the main power switchWhen RoboVac cannot be activated or stops working suddenly and the other checks in the troubleshooting table did not help.
- How to charge RoboVacBefore first use, after a four-beep low-power error, or when RoboVac does not dock by itself.
- How to clean the dust collector and filtersAfter each use for the dust collector and once a week for the filters.
- How to clean the rolling brushOnce a week, or when the rolling brush does not rotate or four beeps sound with a solid red light.
- How to clean the side brushesOnce a month, or after two beeps with a solid red light.
- How to replace the side brushesEvery 3 to 6 months, or when a side brush is bent, damaged or visibly worn.
- How to clean the swivel wheelOnce a month and as needed, when hair or dust is caught in the swivel wheel.
Sources
- Owner's Manual, RoboVac T2108/T2109/T2110. Anker Innovations Limited. Document 51005001324, revision V01, 28 pages, en. service.eufy.com. Listed on the manufacturer's support page. Retrieved 13 November 2026.
Page numbers are the numbers printed in the manual. Where this page and the manual differ, follow the manual.