eufy T2108 solid red
Red status light solid with beeps. RoboVac has an error. The number of beeps identifies it: one, two, three or four beeps.
Cause 1 of 4One beep: the left or right wheel is stuck. Source: Troubleshooting: Error Tones, p. 24
First checkTurn off RoboVac and remove hair or debris from the left and right wheel.
Causes and checks
One beep: the left or right wheel is stuck. Source: Troubleshooting: Error Tones, p. 24
- Turn off RoboVac and remove hair or debris from the left and right wheel.
Two beeps: the side brush is stuck. Source: Troubleshooting: Error Tones, p. 24
- Turn off RoboVac and remove hair or debris from the side brush.
Three beeps: the suction fan is stuck. Source: Troubleshooting: Error Tones, p. 24
- Turn off RoboVac, then remove and empty the dust collector. See Clean the dust collector and filters.
- Check that the suction inlet is not blocked by hair or debris.
Four beeps: the rolling brush is stuck. Source: Troubleshooting: Error Tones, p. 24
- Turn off RoboVac and remove hair or debris from the rolling brush. See Clean the rolling brush.
All 4 causes checked. Contact eufy support.
Service
If the checks above do not clear it, contact eufy support, eufylife.com. Worldwide. Source: Cover, p. 1
Other T2108 indicators
- Breathing orange: RoboVac is charging.
- Solid blue: RoboVac is on standby, cleaning or fully charged.
- Solid orange: Power is low and RoboVac is returning to the Charging Base.
- Light off: RoboVac is off, or the light switched itself off after 1 minute of inactivity while RoboVac is not docked.
- Flashing red: RoboVac has an error. The number of beeps identifies it: two beeps, three beeps or four beeps.
Sources
- Owner's Manual, RoboVac T2108/T2109/T2110. Anker Innovations Limited. Document 51005001324, revision V01, 28 pages, en. service.eufy.com. Listed on the manufacturer's support page. Retrieved 13 November 2026.
Page numbers are the numbers printed in the manual. Where this page and the manual differ, follow the manual.