HP OfficeJet Pro 9010e series wireless light slow blinking
The Wireless light blinks slowly without a clear pause. Wireless is on, but the printer is not connected to a network.
Cause 1 of 2Wireless is on, but the printer is not connected to a network. Source: Overview of buttons and lights, p. 6
First checkMake sure your printer is within the range of the wireless signal.
Causes and checks
Wireless is on, but the printer is not connected to a network. Source: Overview of buttons and lights, p. 6
- Make sure your printer is within the range of the wireless signal.
The printer is in Wireless setup mode and waits for the HP Smart app. After first power-on it searches for the app for two hours, and then stops searching. Source: To set up using the HP Smart app, p. 31
- Open the HP Smart app and add the printer. See Set up the printer with the HP Smart app.
All 2 causes checked. Contact HP support.
Service
If the checks above do not clear it, contact HP support, hp.com/support. Chat with an HP support agent or the HP Virtual Agent online, or call an HP support agent. Free for in-warranty customers. Source: Contact HP, p. 184
Other OfficeJet Pro 9010e series indicators
- Wireless light solid blue: A wireless connection has been established and you can print.
- Wireless light slow blinking with a clear pause: Wireless is on, but the printer is not configured for a network.
- Wireless light fast blinking: A wireless error occurred. A message on the printer display describes it.
- Wireless light off: Wireless is turned off.
- Printer failure: The printer reports a failure with an error code in the message.
- Fax Hardware Test: The "Fax Hardware Test" part of the fax test failed.
- Fax Connected to Active Telephone Wall Jack: The "Fax Connected to Active Telephone Wall Jack" part of the fax test failed.
- Phone Cord Connected to Correct Port on Fax: The "Phone Cord Connected to Correct Port on Fax" part of the fax test failed.
- Using Correct Type of Phone Cord with Fax: The "Using Correct Type of Phone Cord with Fax" part of the fax test failed.
- Dial Tone Detection: The "Dial Tone Detection" part of the fax test failed.
- Fax Line Condition: The "Fax Line Condition" part of the fax test failed.
- Phone Off Hook: Other equipment on the phone line is in use or off the hook.
Sources
- User Guide, HP OfficeJet Pro 9010e All-in-One series. HP Development Company, L.P. Document c06940372, revision ENWW (PDF created 2021-02-26), 219 pages, en. h10032.www1.hp.com (PDF). Retrieved 13 November 2026.
Page numbers are the numbers printed in the manual. Where this page and the manual differ, follow the manual.