Maytag MED6230HW how to prepare a cord-connected dryer for moving
Before moving a dryer that connects with a power supply cord.
Steps
- Unplug the power supply cord.
- Make sure the leveling legs are secure in the dryer base.
- Use tape to secure the dryer door.
- On models with base trim, remove the base trim before moving the dryer. See Remove and install the base trim.
Follow the Installation Instructions to locate, level and connect the dryer again.
Source: Non-Use, Storage, and Moving Care Source: Non-Use, Storage, and Moving Care, p. 29
Other MED6230HW procedures
- How to clean the lint screenBefore or after every load. The lint screen is in the door opening of the dryer.
- How to wash the lint screen with a brushEvery 6 months, or more often if the screen clogs from residue. Detergent and fabric softener residue can lengthen drying times or stop the dryer before the load is dry.
- How to clean the dryer drumWhen the drum needs cleaning.
- How to change the drum light bulbOn models with a drum light, when the bulb needs replacing.
- How to level the dryerWhen the dryer is not level. The dryer must be level for the moisture sensing system to operate correctly.
- How to remove and replace the dryer doorOnly when removal is necessary; removing the door is not suggested for normal use. Make sure the dryer is off and cool. The door is heavy.
- How to remove and install the base trimOn models with base trim, such as before moving the dryer.
- How to prepare the dryer for non-use or storageBefore a vacation or an extended period without using the dryer.
Sources
- Dryer Installation and Care Instructions Manual. Whirlpool Corporation (Maytag). Document W11555818, revision Rev A, 88 pages, en-US. maytag.com (PDF). Listed on the manufacturer's support page. Retrieved 13 November 2026.
Page numbers are the numbers printed in the manual. Where this page and the manual differ, follow the manual.