Maytag MED6230HW how to level the dryer
When the dryer is not level. The dryer must be level for the moisture sensing system to operate correctly.
Steps
- Place a level on the top of the dryer and check levelness from side to side, then from front to back.
- If the dryer is not level, prop it up using a wood block.
- Use a wrench to adjust the leveling legs up or down, and check levelness again.
Source: Level Dryer Source: Level Dryer, p. 21
Used for
Other MED6230HW procedures
- How to clean the lint screenBefore or after every load. The lint screen is in the door opening of the dryer.
- How to wash the lint screen with a brushEvery 6 months, or more often if the screen clogs from residue. Detergent and fabric softener residue can lengthen drying times or stop the dryer before the load is dry.
- How to clean the dryer drumWhen the drum needs cleaning.
- How to change the drum light bulbOn models with a drum light, when the bulb needs replacing.
- How to remove and replace the dryer doorOnly when removal is necessary; removing the door is not suggested for normal use. Make sure the dryer is off and cool. The door is heavy.
- How to remove and install the base trimOn models with base trim, such as before moving the dryer.
- How to prepare the dryer for non-use or storageBefore a vacation or an extended period without using the dryer.
- How to prepare a cord-connected dryer for movingBefore moving a dryer that connects with a power supply cord.
Sources
- Dryer Installation and Care Instructions Manual. Whirlpool Corporation (Maytag). Document W11555818, revision Rev A, 88 pages, en-US. maytag.com (PDF). Listed on the manufacturer's support page. Retrieved 13 November 2026.
Page numbers are the numbers printed in the manual. Where this page and the manual differ, follow the manual.