Maytag MED6230HW how to clean the lint screen

Before or after every load. The lint screen is in the door opening of the dryer.

Steps

  1. Pull the lint screen straight up and out (Style 1) or out of its holder (Style 2).
  2. On Style 1, press the tab down on the front and open the lint screen.
  3. Roll the lint off the screen with your fingers. Do not rinse or wash the screen to remove lint; wet lint is hard to remove.
  4. Push the lint screen firmly back into place.

Do not run the dryer with the lint screen loose, damaged, blocked or missing; this can cause overheating and damage to the dryer and fabrics. If lint falls into the dryer when the screen is removed, check the exhaust hood and remove the lint. Vacuum lint that has gathered around the lint screen opening as needed.

Source: Dryer Care: Cleaning the lint screen Source: Dryer Care: Cleaning the lint screen, p. 27

Used for

Other MED6230HW procedures

Sources

  1. Dryer Installation and Care Instructions Manual. Whirlpool Corporation (Maytag). Document W11555818, revision Rev A, 88 pages, en-US. maytag.com (PDF). Listed on the manufacturer's support page. Retrieved 13 November 2026.

Page numbers are the numbers printed in the manual. Where this page and the manual differ, follow the manual.

Applies to
MED6230HW. United States and Canada.
Source
Dryer Installation and Care Instructions Manual, W11555818 revision Rev A
Last verified
Handbook
Maytag MED6230HW electric dryer in Dryers; all Maytag handbooks