Bosch SHE3AEM2N dishwasher
- Category
- Dishwashers
- Model number
- SHE3AEM2N, SHE3AEM5N, SHE3AEM6N
- Region
- United States and Canada
- Manual
- 9001831729 revision B
- Verified
- Rating label
- On the top or side rim of the door, on a label or engraved. Source: support page
- 4 LEDs lit
- 4 LEDs flashing
- All LEDs lit or flashing
- Rinse aid indicator lit
- Water is left in the tub after the cycle
- Dishes are not dry
- Food is left on the dishes
- Too much foam
- Dishwasher does not start
- Door cannot be closed
- The WLAN display flashes or the connection to the home network is not established
- How to clean the drain pump
- How to clean the filters
- How to clean the spray arms
- How to refill the rinse aid
Nothing on this page matches. Search all models
Indicator lights
| Indicator | Meaning | Checks |
|---|---|---|
| 4 LEDs lit | Water is not draining or not coming in. | 5 causes |
| 4 LEDs flashing | A technical fault. | 1 causes |
| All LEDs lit or flashing | The electronics have detected a fault. | Checks |
| Rinse aid indicator lit | The rinse aid dispenser is empty. | Checks |
All LEDs lit or flashing
Every LED on the control panel lights up or flashes. The electronics have detected a fault.
- Hold the ON/OFF button for about 4 seconds. The dishwasher resets and restarts.
- If it happens again, switch the dishwasher off, unplug it or switch off its breaker, wait at least 2 minutes, then restore power and switch it on.
Rinse aid indicator lit
The rinse aid refill indicator lights up. The rinse aid dispenser is empty.
- Refill the rinse aid dispenser. See Refill the rinse aid.
- Check the rinse aid dispensing level (Settings below).
Problems
- Water is left in the tub after the cycle2 causes in the manual. First: the filter system or the area under the filters is blocked.
- Dishes are not dry7 causes in the manual. First: no rinse aid is used, or the dosage is set too low.
- Food is left on the dishes9 causes in the manual. First: dishware was placed too close together or the rack is overfilled.
- Too much foam3 causes in the manual. First: hand soap got into the rinse aid dispenser.
- Dishwasher does not start3 causes in the manual. First: the breaker has tripped.
- Door cannot be closed2 causes in the manual. First: the door lock has engaged.
- The WLAN display flashes or the connection to the home network is not established2 causes in the manual. First: the WLAN on the router is not active, or the home network is not available.
Tub walls are wet after the cycle
Normal. The dishwasher dries by condensation: moisture settles on the tub walls, runs down and is pumped out. Source: Troubleshooting (cont.), p. 25
How-to
- How to clean the drain pumpWhen water no longer drains properly, or the four vertical LEDs light up and the pump cover is secure.
- How to clean the filtersCheck the filters after every wash. Clean them when you see residue, when food is left on dishes, or when water stays in the tub.
- How to clean the spray armsRegularly, and when food is left on dishes. Limescale and food can block the nozzles and bearings.
- How to refill the rinse aidWhen the rinse aid refill indicator lights up. Use only rinse aid made for household dishwashers.
Maintenance
| Task | When | Source |
|---|---|---|
| Check the filters for residue after each wash and clean them | After each wash | Source: Cleaning and maintenance: Filter system, p. 22 |
| Clean the spray arms | Regularly | Source: Cleaning and maintenance: Cleaning the spray arms, p. 23 |
| Clean the tub by running the highest-temperature program with detergent and no dishware. Never use detergents containing chlorine. | Source: Cleaning and maintenance: Cleaning the tub, p. 22 | |
| Wipe the door seals, the front and the control panel with a damp cloth and dish soap | Regularly | Source: Cleaning and maintenance: Tips on appliance care, p. 22 |
Settings
| Setting | Options | Default | Notes | Source |
|---|---|---|---|---|
| Rinse aid dispensing | Scale with 4 levels; switching the amount off leaves no LED lit | A lower level reduces streaks; a higher level reduces water spots and improves drying. Switching it off deactivates the rinse aid refill indicator. | Source: Basic settings; Rinse aid system, pp. 13, 19 | |
| Intensive drying | On, Off | Off | Raises the temperature in the final rinse and may lengthen the run time slightly. Not for delicate dishware. | Source: Basic settings, p. 19 |
| Signal volume | 4 levels; 0, 1, 2 or 3 LEDs light up | Level 2 | Source: Basic settings; Home Connect, p. 20 | |
| Wi-Fi | On, Off; the Wi-Fi LED shows whether it is on | Off | Appears after the dishwasher is connected to the Home Connect app. | Source: Basic settings; Home Connect, pp. 19-20 |
| Factory setting | Reset | Restores the changed settings to the factory settings; the initial-use settings must be configured again. | Source: Basic settings; Home Connect, p. 20 |
Cycles
| Cycle | Use | Run time (h:mm) | Source |
|---|---|---|---|
| Heavy | Pots, pans, non-fragile dishware and silverware with stubborn burned or dried-on food. Cleaning at 151–160 °F, final rinse at 162 °F. | 1:40–2:10 h, 4.9–6.4 gal | Source: Dishwasher Cycles, p. 10 |
| Auto | Mixed dishware and silverware with common household food remnants lightly dried on. Sensor controlled. | 2:05–2:15 h, 3.4–6.3 gal | Source: Dishwasher Cycles, p. 10 |
| Normal | Mixed dishware and silverware with lightly dried-on remnants. Most economical cycle; cleaning at 122–131 °F, final rinse at 154 °F. | 2:15–2:20 h, 2.4–5.5 gal | Source: Dishwasher Cycles, p. 10 |
| Speed 60 | Mixed dishware and silverware with lightly dried-on remnants. Time-optimized; cleaning at 122 °F, final rinse at 158 °F. | 1:00 h, 3.8 gal | Source: Dishwasher Cycles, p. 10 |
| Favorite | A saved combination of a cycle and an option, set up in the Home Connect app. | 2:05–2:15 h | Source: Dishwasher Cycles, pp. 10-11 |
Parts and consumables
| Item | Replace or refill | Specification | Source |
|---|---|---|---|
| Rinse aid | – | Rinse aid for household dishwashers; the refill indicator lights up when the dispenser needs filling | Source: Rinse aid system, p. 12 |
Specifications
Built-in dishwasher for 14 place settings. Faults show as LED patterns, such as all four vertical LEDs lit or flashing. Source: Troubleshooting, pp. 24, 33
The four vertical LEDs are the three cycle-duration indicators and the Clean indicator. All four lit means water is not draining or not coming in; all four flashing means a technical fault. Source: Troubleshooting, p. 24
Cycles on the control panel: Heavy, Auto, Normal, Speed60 and a saved Favorite. Options: Sanitize, Remote Start and Extra Dry. Source: Controls; Dishwasher Cycles; Options, pp. 8, 10-11
| Capacity | 14 place settings | Source: Technical specifications, p. 33 |
|---|---|---|
| Electrical | 120 V, 60 Hz, 1440 W, 12 A fuse | Source: Technical specifications, p. 33 |
| Water pressure | 7.25–145 psi (50–1000 kPa) | Source: Technical specifications, p. 33 |
| Minimum inlet rate | 2.6 gal/min | Source: Technical specifications, p. 33 |
| Supply water | Cold, or hot up to 140 °F (60 °C) | Source: Technical specifications, p. 33 |
| Maximum weight | 132 lb (60 kg) | Source: Technical specifications, p. 33 |
| Sound level | 50 dBA | Source: General Properties, p. 1 |
Recalls
No exact-model match for SHE3AEM2N in the U.S. Consumer Product Safety Commission recall database, checked . Recalls can name model families, so also check current recalls for Bosch.
Service contact
Bosch Customer Service: 1-800-944-2904, bosch-home.com/us/owner-support/get-support. United States and Canada. Source: Customer Service, p. 31
Sources
- Use and Care Manual, Dishwasher SHE3AEM2N. BSH Home Appliances Corporation. Document 9001831729, revision B, 36 pages, en-US. media3.bsh-group.com (PDF). Listed on the manufacturer's support page. Retrieved 13 November 2026.
- Use and Care Manual, Dishwasher SHE3AEM6N. BSH Home Appliances Corporation. Document 9001831733, revision B, 36 pages, en-US. media3.bosch-home.com (PDF). Listed on the manufacturer's support page. Retrieved 13 November 2026.
- Specification sheet, Dishwasher SHE3AEM2N. BSH Home Appliances Corporation. Document 21844544, revision SHE3AEM2N, 3 pages, en-US. media3.bsh-group.com (PDF). Listed on the manufacturer's support page. Retrieved 13 November 2026.
Page numbers are the numbers printed in the manual. Where this page and the manual differ, follow the manual.
All Bosch handbooks. Report an error to hello@modelhandbook.com.