HP M209dw how to open the Embedded Web Server (EWS)
Before any step that uses the EWS.
Steps
- Press the Information button on the printer to print an information page, and read the IP address.
- Type the IP address or hostname in a web browser address bar and press Enter.
- Select the option to continue if the browser warns that the site is unsafe.
- Enter the user name admin and the password from the label inside the cartridge access door if prompted.
Other ways in: HP Smart (select the printer, then Advanced Settings), HP printer software, or the Wi-Fi Direct address 192.168.223.1.
Source: Configure the printer using the Embedded Web Server (EWS) Source: Configure the printer using the Embedded Web Server (EWS), pp. 27-28
Other M209dw procedures
- How to clear a jam from the input trayWhen the Paper light blinks and paper is stuck at the input tray.
- How to clear a jam in the printer baseWhen paper is stuck at the bottom of the printer.
- How to clear a jam in the print cartridge areaWhen paper is stuck behind the cartridge.
- How to clear a jam in the rear duplexerWhen paper is stuck at the back of the printer.
- How to load paper in the input trayWhen the Paper light blinks because the tray is empty.
- How to clean the pickup rollerWhen the printer does not pick up paper and the earlier checks did not help.
- How to replace the toner cartridgeWhen the print cartridge nears the end of its life and redistributing toner no longer gives acceptable print quality.
- How to redistribute toner in the cartridgeWhen the Cartridge light shows low toner and print quality is still acceptable.
- How to inspect the toner cartridgeWhen print quality is poor or the page prints black.
- How to clean the cartridge with Cartridge Cleaning ModeWhen pages show background shading, vertical dark bands or repeating horizontal banding.
- How to print a cleaning pageWhen pages show toner specks, spatter, smears, streaks, lines or repeating marks.
- How to connect the printer to Wi-Fi with HP SmartFor first setup, after turning wireless off, or after restoring network settings.
- How to connect the printer to Wi-Fi with WPSWhen the router has a WPS button.
- How to connect the printer to an Ethernet networkWhen you want a wired connection on a model with an Ethernet port.
- How to restore network settings to defaultWhen the printer must return to wireless setup mode.
- How to print a configuration reportTo see the printer usage log, event logs, network status and settings.
- How to print a Wireless Network Test ReportWhen the printer will not connect to Wi-Fi.
- How to restore the original factory defaultsAfter disabling functions or changing settings you want to undo.
- How to turn Cartridge Policy on or offTo allow only genuine HP cartridges, or to remove that restriction.
- How to change what the printer does when the cartridge is Very LowTo make the printer stop, or keep printing, at the Very Low state.
- How to adjust print densityWhen prints are consistently too light or too dark.
Sources
- User Guide, HP LaserJet M207-M212 series. HP Development Company, L.P. Document c06977277, revision EN-WW (PDF created 2020-12-03), 133 pages, en. h10032.www1.hp.com (PDF). Retrieved 13 November 2026.
Page numbers are the numbers printed in the manual. Where this page and the manual differ, follow the manual.