Samsung WA50R5200AW how to run calibration
Recommended initial setting. Calibration lets the washer detect load weight accurately.
Steps
- Make sure the tub is empty.
- Press Power to turn on the washer.
- Press and hold Temp. and Delay End at the same time for 3 seconds.
- Press and hold Start/Pause (Hold to Start) to start calibration. The tub rotates clockwise or counterclockwise for approximately 2 minutes.
- Wait until "0" appears on the display and the washer turns off automatically.
Source: Before you start: Initial settings Source: Before you start: Initial settings, p. 28
Other WA50R5200AW procedures
- How to run the SELF CLEAN cycleAt least once a month or every 20 cycles. The SELF CLEAN reminder icon blinks for an hour after 20 washing cycles.
- How to clean the mesh filters in the water inletsOnce or twice a year. The 4C code appears when a mesh filter is clogged.
- How to clean the detergent drawerWhen detergent remains in the dispenser after a cycle.
- How to prepare the washer for a long period without useWhen you will leave the washer unused for a long time. The manual advises against leaving it unused for an extended time.
Sources
- User manual, Washer WA54R7200A* / WA50R5200A*. Samsung Electronics America, Inc. Document DC68-04037J-05, revision 05, 72 pages, en. downloadcenter.samsung.com (PDF). Listed on the manufacturer's support page. Retrieved 13 November 2026.
Page numbers are the numbers printed in the manual. Where this page and the manual differ, follow the manual.