Bosch WGG244A9GB how to fill the i-DOS dispensers
When a dispenser symbol flashes, or before using i-DOS for the first time.
Steps
- Pull out the detergent drawer and open the dispenser cover.
- Pour liquid detergent and fabric softener into their dispensers, no higher than the maximum mark. To change product, clean the drawer first.
- Close the dispenser cover straight away so the product does not dry out.
- Push the drawer in and check the basic dosage. See Set the i-DOS basic dosage.
Source: 15.2 Filling the dispensers Source: 15.2 Filling the dispensers, p. 34
Used for
- i-DOS dispenser symbol flashing: That i-DOS dispenser is below its minimum fill level.
Other WGG244A9GB procedures
- How to empty and clean the drain pumpWhen water does not drain (E:36 / -10), after blockages, or when the pump rattles.
- How to clean the detergent drawer and i-DOS pump unitWhen the drawer is dirty, when changing to a different i-DOS product, or when E:10 shows.
- How to run Drum CleanBefore first use, regularly if you wash at 40 °C or lower, after a long time unused, and when the drum clean reminder flashes.
- How to turn the childproof lock on or offTo stop the controls being changed. The lock stays on after switching off and after a power cut.
- How to open the door with the emergency releaseWhen the door stays locked after a power failure.
- How to level the washing machineAfter installation or moving, and when it vibrates, moves or is loud during spin.
- How to set the i-DOS basic dosageAfter filling a new product, and when there is too much foam or residue. Set the dose the detergent maker gives for a standard 4.5 kg load at your water hardness.
Sources
- User manual and installation instructions, Washing machine WGG244A9GB. BSH Hausgeräte GmbH. Document 9001640606, revision A, 60 pages, en-GB. media3.bsh-group.com (PDF). Listed on the manufacturer's support page. Retrieved 13 November 2026.
Page numbers are the numbers printed in the manual. Where this page and the manual differ, follow the manual.