Gne27jymfs reset water filter
When the red filter light starts blinking, every six months at the rated capacity, or sooner if water flow to the dispenser or icemaker decreases.
You need
- Replacement filter XWFE
Steps
If air has been trapped in the system, the filter cartridge may be ejected as it is removed. Use caution when removing.
Marked CAUTION by the manufacturer Source: Using the Refrigerator: Water Filter Cartridge - XWFE, p. 14
- Open the filter cartridge housing, at the back upper-right corner of the refrigerator compartment, by squeezing the 2 front tabs and gently pulling down.
- Rotate the old filter down, grasp it and slowly turn it counterclockwise about a quarter turn. It releases itself when turned far enough; a little water may drip.
- Line up the ports on the new filter with the ports on the cartridge holder and gently insert the filter.
- Slowly turn the filter to the right until it stops, without overtightening. It moves about a quarter turn (90 degrees) until its arrow aligns with the arrow on the holder.
- Slowly push the filter up into the clips and close the housing by pushing the lid up until the tabs lock.
- For dispenser-only models, run water from the dispenser for 2 gallons (7.6 liters), about 5 minutes. For icemaker-only models, discard the first bin of ice.
- Press and hold the RESET WATER FILTER button on the dispenser for 3 seconds. On select models the reset happens automatically when a new filter is installed.
The dispenser and icemaker do not operate without either the filter or the filter bypass plug installed. The bypass plug is installed in the same way as a filter cartridge.
Source: Using the Refrigerator: Water Filter Cartridge - XWFE Source: Using the Refrigerator: Water Filter Cartridge - XWFE, pp. 14-15
Used for
- LEAK: The refrigerator detected a leak at the water filter. The Filter Status indicator LED flashes red.
- Filter Status LED red: The filter is reaching its expired state or has expired. If the LED stays red after a replacement, the filter was installed incorrectly, a leak is detected, or an expired filter was installed. When the unit detects a new filter, the LED flashes 3 times and then stays off.
- Automatic icemaker does not work
- Water dispenser does not work
Other GNE27JYMFS procedures
- How to set the refrigerator and freezer temperatureTo change the temperature on the GNE27J top control. The refrigerator is preset to 37 °F (2.8 °C) and the freezer to 0 °F (-17.8 °C).
- How to switch the display between °F and °CWhen the temperature display shows the wrong unit.
- How to turn on TurboCoolAfter adding a large amount of food, putting away food that sat at room temperature, or after a long power outage.
- How to turn on the door alarmTo get a beep when a door stays open.
- How to turn the refrigerator control offTo stop cooling without unplugging, for example before cleaning.
- How to turn off showroom modeWhen the refrigerator is plugged in, the display works, but nothing cools.
- How to turn the icemaker on or offBefore the water line is connected, when the water supply is off, or to stop the buzzing of the water valve.
- How to clear cubes stuck in the icemakerWhen the icemaker has stopped making ice and cubes are stuck in it.
- How to turn Sabbath mode on or offTo use the refrigerator on the Sabbath and holidays.
- How to level the refrigerator and doorsWhen the refrigerator vibrates, a door does not close by itself, or the French doors are uneven.
- How to prepare the refrigerator for a long absenceFor long vacations or absences.
Sources
- Owner's Manual & Installation Instructions, Refrigerators Bottom Freezer, GE and GE Profile models 18, 19, 21, 22, 24, 25, 26 and 27 cu ft. GE Appliances, a Haier company. Document 49-1000472, revision Rev 10, 156 pages, en-US. images.salsify.com (PDF). Listed on the manufacturer's support page. Retrieved 13 November 2026.
- Quick Specs, GNE27JGM/JMM/JYM 27.0 cu. ft. French-Door Refrigerator. GE Appliances. Document GNE27JGM/JMM/JYM, revision Specification revised 12/24, 2024-12, 2 pages, en-US. images.salsify.com (PDF). Listed on the manufacturer's support page. Retrieved 13 November 2026.
Page numbers are the numbers printed in the manual. Where this page and the manual differ, follow the manual.