LG LRGL5823S how to run EasyClean
To loosen light soil with water and a 10-minute low-temperature cycle before hand-cleaning.
Steps
- Let the oven cool to room temperature. EasyClean does not start while the cavity is above 150 °F (65 °C).
- Remove the oven racks and accessories.
- Scrape burnt-on debris off with a plastic scraper.
- Fill a spray bottle with 10 oz (300 ml) of water. Spray at least 1/5 of it (2 oz or 60 ml) on the walls and corners to saturate the soil.
- Spray or pour the remaining 8 oz (250 ml) onto the bottom center until the indentation in the oven bottom is fully covered.
During the EasyClean® cycle, the oven becomes hot enough to cause burns. Wait until the cycle is over before wiping the inside surface of the oven. Failure to do so may result in burns.
Marked CAUTION by the manufacturer Source: Maintenance: EasyClean, p. 48
- Close the door, press EasyClean, then press Start.
- When the tone sounds at the end of 10 minutes, press Clear/Off.
- Scrub the oven cavity right away with a wet non-scratch scouring sponge or pad, keeping enough water on the oven bottom to cover the soil.
- Wipe up the excess water with a dry towel and replace the racks and accessories.
- If light soil remains, repeat the steps, soaking the soiled areas.
Do not open the oven door during the cycle, because the water will not get hot enough. If you forget to add water, press Clear/Off, let the range cool and start again. Commercial oven cleaners and bleach are not recommended, and no steel scouring pads or abrasive cleaners should be used.
Source: Maintenance: EasyClean Source: Maintenance: EasyClean, pp. 47-48
Used for
- Hot: The oven cavity is above 150 °F (65 °C), so EasyClean will not start until the oven cools.
- The oven is still dirty after EasyClean
Other LRGL5823S procedures
- How to light a surface burnerTo light a sealed gas burner with the electric spark igniter.
- How to light a surface burner during a power failureWhen the power is out. The oven and broiler cannot be used, but the surface burners can be lit with a match.
- How to set the clockTo set or reset the time of day. The clock must be right for the automatic oven timing functions to work.
- How to turn Lockout on or offTo keep the oven from being started, or to clear LOCKED. On LRGL5825* and LRGL5823*, Lockout also locks the oven door.
- How to adjust the oven thermostatWhen the oven is hotter or cooler than expected after a few weeks of use.
- How to turn convection Auto Conversion on or offTo control whether the oven converts a regular recipe temperature when you use Conv. Bake or Conv. Roast (LRGL5825* and LRGL5823*).
- How to set Sabbath modeBefore cooking on the Sabbath or a holiday. Sabbath mode works only with Bake.
- How to run Self CleanWhen the oven needs more than EasyClean can remove. LRGL5825* and LRGL5823* only.
- How to replace the oven light bulbWhen the oven light does not work.
- How to clean the burner heads and capsWhen a burner does not light or burn evenly, and after spillovers.
- How to remove and replace an oven rackTo take a rack out or move it. Only change racks when the oven is cool.
Sources
- Owner's Manual, Gas Range LRGL5825*, LRGL5823* and LRGL5821*. LG Electronics Inc. Document MFL33029630, revision Rev.18, 2025-01-24, 125 pages, en-US. gscs-b2c.lge.com. Listed on the manufacturer's support page. Retrieved 13 November 2026.
Page numbers are the numbers printed in the manual. Where this page and the manual differ, follow the manual.