Miele G 7200 error Water intake
There is a water inlet fault.
CauseThere is a water inlet fault. Source: Problem solving guide: Water inlet fault, p. 81
First checkSwitch the dishwasher off, open the stopcock fully and start the programme again.
Causes and checks
There is a water inlet fault. Source: Problem solving guide: Water inlet fault, p. 81
- Switch the dishwasher off, open the stopcock fully and start the programme again.
- Clean the filter in the water inlet. See Clean the water inlet filter.
Licensed plumber If the water connection pressure is lower than 50 kPa, seek professional advice.Licensed plumber The on-site connection for the water drainage may be too low, in which case the water drainage needs venting (Installation chapter, section Water drainage).Miele Customer Service Department If the fault message is displayed again, there may be a technical fault with the impeller flow meter. Contact Miele Customer Service or a qualified specialist. Contact: 0330 160 6600 or miele.co.uk.
Service
If the checks above do not clear it, contact Miele Customer Service Department: 0330 160 6600, miele.co.uk. United Kingdom. Source: Back cover: United Kingdom, p. 99
Other G 7200 codes
- Fault FXX: There may be a technical fault.
- Fault F78: Circulation pump fault.
- Fault F18: A technical fault.
- Waterproof: The water protection system (Waterproof system) has reacted.
- Door fault: The door does not open automatically, or the door lock catches do not retract after the door is opened.
- Open stopcock: The stopcock is closed.
- Drain: A water drainage fault. There might be water in the wash cabinet.
- Check filters: The filter combination is due for checking after every 50 programme cycles.
Sources
- Operating instructions, Dishwashers G 7200, G 7202, G 7205, G 7207. Miele & Cie. KG. Document M.-Nr. 11 952 311, revision / 01, HG07, en-GB, 100 pages, en-GB. media.miele.com (PDF). Retrieved 13 November 2026.
Page numbers are the numbers printed in the manual. Where this page and the manual differ, follow the manual.