Miele G 7200 how to clean the water inlet filter
When the Water intake message appears or too little water flows into the wash cabinet.
Steps
WARNING
Risk of electric shock from mains voltage. The plastic housing of the water connection contains an electrical valve. The housing must not be immersed in liquids.
Signal word assigned by Model Handbook Source: Cleaning and care: Cleaning the water inlet filter, p. 75
- Switch the dishwasher off and unplug the mains plug.
- Close the stopcock.
- Unscrew the water intake valve.
- Remove the filter and the sealing washer from the screw connection. A pair of pliers can help.
- Rinse the filter under running water.
- Reassemble in reverse order. The filter must be refitted after cleaning.
- Screw the screw thread securely back onto the stopcock and turn the stopcock on slowly. If water drips out, tighten the connection.
Source: Cleaning and care: Cleaning the water inlet filter Source: Cleaning and care: Cleaning the water inlet filter, p. 75
Used for
- Water intake: There is a water inlet fault.
Other G 7200 procedures
- How to clean the filter combinationWhen the Check filters message appears after 50 programme cycles, or when the Drain message or water left in the cabinet points to a clogged filter.
- How to clean the drain pumpWhen water remains in the wash cabinet after the end of the programme, or the Drain message appears.
- How to open the door by handWhen the Door fault message shows that the door did not open automatically.
Sources
- Operating instructions, Dishwashers G 7200, G 7202, G 7205, G 7207. Miele & Cie. KG. Document M.-Nr. 11 952 311, revision / 01, HG07, en-GB, 100 pages, en-GB. media.miele.com (PDF). Retrieved 13 November 2026.
Page numbers are the numbers printed in the manual. Where this page and the manual differ, follow the manual.