Bosch SHE53C85N dishwasher
- Category
- Dishwashers
- Model number
- SHE53C85N, SHE53C85N/34
- Region
- United States and Canada
- Manual
- 9001641447 revision C
- Verified
- Rating label
- Inside the appliance door. The rating plate shows the product number (E-Nr.) and production number (FD). Source: Use and Care Manual, Dishwasher SHE53C85N, p. 45On the top or side rim of the door, on a label or engraved. Source: support page
- 4 LEDs lit
- 4 LEDs flashing
- All LEDs lit or flashing
- Rinse aid indicator lit
- Water is left in the tub after the cycle
- Dishes are not dry
- Food is left on the dishes
- Glasses and cutlery have wipeable streaks
- Too much foam
- Dishwasher does not start
- Door will not close
- How to clean the filters
- How to clean the drain pump
- How to clean the spray arms
- How to refill the rinse aid
Nothing on this page matches. Search all models
Indicator lights
| Indicator | Meaning | Checks |
|---|---|---|
| 4 LEDs lit | Water is not draining or not coming in, or the supply voltage is too low. Bosch lists six causes. | 6 causes |
| 4 LEDs flashing | Bosch describes this as a technical fault and gives no owner-level cause. | Checks |
| All LEDs lit or flashing | Either a software update is installing or the electronics have detected a fault. | Checks |
| Rinse aid indicator lit | The rinse aid dispenser is empty. | Checks |
4 LEDs flashing
All four vertical LEDs (cycle-duration indicators and Clean) flash. Bosch describes this as a technical fault and gives no owner-level cause.
- Switch the dishwasher off.
- Unplug it, or switch off its circuit breaker.
- Wait at least 2 minutes.
- Plug it back in or switch the breaker on, then switch the dishwasher on.
All LEDs lit or flashing
Every LED on the control panel lights up or flashes. Either a software update is installing or the electronics have detected a fault.
A software update may be installing. This can take about 30 minutes. Source: 16 Troubleshooting, p. 40
- Wait until the update finishes.
- If the dishwasher is still not ready after 30 minutes, hold the main switch button for about 4 seconds to reset it.
The electronics have detected a fault. Source: 16 Troubleshooting, p. 40
- Hold the main switch button for about 4 seconds. The dishwasher resets and restarts.
- If it happens again, switch the dishwasher off, unplug it or switch off its breaker, wait at least 2 minutes, then restore power and switch it on.
Rinse aid indicator lit
The rinse aid refill indicator lights up. The rinse aid dispenser is empty.
- Refill the rinse aid dispenser. See Refill the rinse aid.
- Check the rinse aid dispensing level (Settings below).
Problems
- Water is left in the tub after the cycle2 causes in the manual. First: the filters, or the area under them, are blocked.
- Dishes are not dry6 causes in the manual. First: no rinse aid, or the dispensing level is too low.
- Food is left on the dishes8 causes in the manual. First: dishes are placed too close together or the rack is overfilled.
- Glasses and cutlery have wipeable streaks4 causes in the manual. First: the amount of rinse aid to be dispensed is set too high.
- Too much foam3 causes in the manual. First: hand soap got into the rinse aid dispenser.
- Dishwasher does not start4 causes in the manual. First: the breaker has tripped.
- Door will not close2 causes in the manual. First: the door lock has engaged.
Tub walls are wet after the cycle
Normal. The dishwasher dries by condensation: moisture settles on the tub walls, runs down and is pumped out. Source: 16 Troubleshooting, p. 35
How-to
- How to clean the filtersCheck the filters after every wash. Clean them when you see residue, when food is left on dishes, or when water stays in the tub.
- How to clean the drain pumpWhen water no longer drains properly, or the four vertical LEDs light up and the pump cover is secure.
- How to clean the spray armsRegularly, and when food is left on dishes. Limescale and food can block the nozzles and bearings.
- How to refill the rinse aidWhen the rinse aid refill indicator lights up. Use only rinse aid made for household dishwashers.
Maintenance
| Task | When | Source |
|---|---|---|
| Check the filters for residue | After every wash | Source: 15.4 Filter system, p. 32 |
| Clean the spray arms | Regularly (no fixed interval given) | Source: 15.5 Cleaning the spray arms, p. 32 |
| Wipe the door seals, front and control panel with a damp cloth and dishwashing liquid | Regularly (no fixed interval given) | Source: 15.3 Tips on appliance care, p. 31 |
| Clean the tub: add dishwasher detergent and run the hottest cycle empty | Source: 15.1 Cleaning the tub, p. 31 | |
| Refill the rinse aid | When the refill indicator lights up | Source: 9.1 Rinse aid, p. 18 |
| Leave the door slightly open to prevent odours | When the dishwasher will not be used for a while | Source: 15.3 Tips on appliance care, p. 31 |
| Have the dishwasher winterized by a professional service (professional service) | Before a long period unused where it may freeze | Source: 17.2 Vacation and Storage, p. 44 |
Settings
| Setting | Options | Default | Notes | Source |
|---|---|---|---|---|
| Rinse aid dispensing | Off, 1, 2, 3 | 2 | Lower if glasses streak; raise for water spots or poor drying. | Source: 9.2 Setting the amount of rinse aid, p. 19 |
| Intensive drying | On, Off | Off | Raises the final-rinse temperature for better drying; run time increases slightly. Take care with delicate dishware. | Source: 13.1 Overview of the basic settings, p. 27 |
| Signal volume | 0, 1, 2, 3 | 2 | Source: Setting the signal volume, p. 28 | |
| Wi-Fi | On, Off | Off | Available after the dishwasher has been connected with the Home Connect app. | Source: 13.1 Overview of the basic settings, p. 27 |
| Automatic switch-off | Fixed | 10 minutes after the cycle ends; 4 seconds if the door is opened right after the end | Source: 12.6 Starting the wash cycle, pp. 25-26 | |
| Factory setting | Reset | Restores all basic settings; the initial-use settings must then be set again. | Source: 13.1 Overview of the basic settings, p. 27 |
Cycles
| Cycle | Use | Run time (h:mm) | Source |
|---|---|---|---|
| Heavy | Pots, pans and sturdy dishes with burnt-on or dried-on food | 1:50–2:20 | Source: 5 Dishwasher Cycles, p. 12 |
| Auto | Mixed loads; sensors adjust to how dirty the water is | 1:45–2:09 | Source: 5 Dishwasher Cycles, p. 12 |
| Normal | Mixed loads, lightly dried-on food; most economical | 2:10–2:15 | Source: 5 Dishwasher Cycles, p. 13 |
| Speed60 | Mixed loads, lightly dried-on food | 1:00 | Source: 5 Dishwasher Cycles, p. 13 |
Parts and consumables
| Item | Replace or refill | Specification | Source |
|---|---|---|---|
| Rinse aid | When the refill indicator lights up | Rinse aid for household dishwashers | Source: 9.1 Rinse aid, p. 18 |
| Detergent | – | Dishwasher detergent, basic or combination. Bosch recommends a separate detergent plus rinse aid for best results. | Source: 10.1 The correct detergents, p. 19 |
Specifications
Built-in dishwasher for 16 place settings, rated 120 V, 60 Hz, 1440 W on a 12 A fuse. Source: 19 Technical specifications, p. 45
Faults show as patterns of the four vertical LEDs (the cycle-duration indicators and the Clean indicator), not as numbered codes. Source: 16 Troubleshooting, p. 33
The rating plate with the product number (E-Nr.) and production number (FD) is inside the door. Customer Service asks for both. Source: 18.1 Model number (E-Nr.), production number (FD) and consecutive numbering (Z-Nr.), p. 45
| Capacity | 16 place settings | Source: 19 Technical specifications, p. 45 |
|---|---|---|
| Water pressure | 7.25–145 psi (50–1000 kPa) | Source: 19 Technical specifications, p. 45 |
| Minimum inlet rate | 2.6 gal/min | Source: 19 Technical specifications, p. 45 |
| Supply water | Cold, or hot up to 140 °F (60 °C) | Source: 19 Technical specifications, p. 45 |
| Electrical | 120 V, 60 Hz, 1440 W, 12 A fuse | Source: 19 Technical specifications, p. 45 |
| Maximum weight | 132 lb (60 kg) | Source: 19 Technical specifications, p. 45 |
Recalls
No exact-model match for SHE53C85N in the U.S. Consumer Product Safety Commission recall database, checked . Recalls can name model families, so also check current recalls for Bosch.
Service contact
Bosch Customer Service: 1-800-944-2904, bosch-home.com/us/owner-support/get-support. United States and Canada. Source: 18 Customer Service, p. 44
Sources
- Use and Care Manual, Dishwasher SHE53C85N. BSH Home Appliances Corporation. Document 9001641447, revision C, 48 pages, en-US. media3.bsh-group.com (PDF). Listed on the manufacturer's support page. Retrieved 12 November 2026.
Page numbers are the numbers printed in the manual. Where this page and the manual differ, follow the manual.
All Bosch handbooks. Report an error to hello@modelhandbook.com.