JURA E8 (ED) how to clean the milk system
Daily when milk has been prepared, or when ‘Milk system cleaning’ appears.
You need
- JURA milk system cleaner
- Milk system cleaning container (supplied)
Steps
- Hold the maintenance/settings button for about 2 seconds to open the JURA Cockpit.
- Press ‘Milk system cleaning’, then ‘Start’.
- Take the milk pipe out of the milk container or cooler.
- Pour one dose of JURA milk system cleaner into the milk system cleaning container.
- Place the container under the coffee spout and frother, push the frother down onto it and connect the milk pipe to the container.
- Press ‘Start’. Cleaning stops by itself.
Source: 7 Maintenance: Cleaning the milk system Source: 7 Maintenance: Cleaning the milk system, pp. 16–17
Used for
- Milk system cleaning: The milk system needs cleaning.
- Too little milk foam, or milk sprays from the frother
Other E8 (ED) procedures
- How to descale the E8When ‘Descaling’ appears in the Cockpit. Takes about 20 minutes; do not interrupt it.
- How to insert or change the CLARIS Smart+ filterWhen the filter symbol lights red or ‘Filter’ shows in the Cockpit.
- How to run the cleaning programmeWhen ‘Cleaning’ appears in the Cockpit (after 180 preparations or 80 switch-on rinses). Takes about 20 minutes; do not interrupt it.
- How to dismantle and rinse the fine foam frotherAbout once a week, and when foam is poor or milk sprays.
- How to descale the water tankFrom time to time, when limescale forms in the tank.
Sources
- Instructions for Use, E8 (ED/SD/INTD) (English). JURA Elektroapparate AG. Document E8(D)/en, revision 20250918_BA-Online, 2025-09-18, 25 pages, en. jura.com (PDF). Listed on the manufacturer's support page. Retrieved 13 November 2026.
Page numbers are the numbers printed in the manual. Where this page and the manual differ, follow the manual.