Ninja OS401 how to install and remove the condensation collector
Before first use, and to hand-wash the collector after each use.
Steps
- To install the condensation collector, slide it into the slot on the cooker base.
- To remove it for hand-washing, slide it out.
Source: Before First Use: Installing the Condensation Collector Source: Before First Use: Installing the Condensation Collector, p. 9
Other OS401 procedures
- How to release pressure with the quick releaseOnly when the recipe calls for it, after pressure cooking is complete and the KEEP WARM light is on.
- How to release pressure naturallyWhen pressure cooking is complete and the recipe does not call for a quick release.
- How to install the pressure lidBefore using the Pressure Cook, Steam, Sous Vide, Slow Cook or Yogurt function.
- How to remove the pressure lidAfter the pressure has been released and the float valve has dropped.
- How to pressure cookWhen a recipe uses the Pressure Cook function.
- How to run a first Pressure Cook test with waterBefore first use. The guide recommends an initial run to get familiar with pressure cooking.
- How to remove and reinstall the silicone ringTo wash the ring after use or to replace it.
- How to remove and clean the anti-clog capAfter every use, and when checking the valves before cooking.
- How to clean the unit after useAfter every use.
Sources
- OS401 Owner's Guide: Foodi 10-in-1 8-QT XL Pressure Cooker. SharkNinja Operating LLC. Document OS401_IB, revision MP_REV_Mv12, 25 pages, en. ninjakitchen.com. Listed on the manufacturer's support page. Retrieved 13 November 2026.
Page numbers are the numbers printed in the manual. Where this page and the manual differ, follow the manual.