GE Appliances GDT645SYNFS controls respond but the dishwasher never fills with water
Cause 1 of 3The door is not completely closed. Source: Troubleshooting Tips: Dishwasher never filled with water, p. 23
First checkClose the door firmly.
Causes and checks
The door is not completely closed. Source: Troubleshooting Tips: Dishwasher never filled with water, p. 23
- Close the door firmly.
The water valve is turned off. Source: Troubleshooting Tips: Dishwasher never filled with water, p. 23
- Turn on the water valve, usually under the sink.
The flood float is stuck. Source: Troubleshooting Tips: Dishwasher never filled with water, p. 23
- Remove the Ultra-Fine Filter and lightly tap the part under it that looks like a salt shaker. See Clean the filters.
- Refit the filter.
All 3 causes checked. Contact GE Appliances: 800.432.2737.
Service
If the checks above do not clear it, contact GE Appliances: 800.432.2737, geappliances.com/. United States, for service (general enquiries 800.626.2000). Canada: 800.561.3344. Source: Consumer Support, p. 26
Other GDT645SYNFS problems
- Dishwasher won't start or run4 causes in the manual. First: the Start sequence was not followed. The cycle starts only if the door is closed within 4 seconds of pressing Start.
- Water left in the bottom of the tub or not pumping out2 causes in the manual. First: the air gap is clogged, or the drain loop or air gap was not installed as the installation instructions require.
- Dishes and flatware are not clean5 causes in the manual. First: the Ultra-Fine Filter or the Fine Filter is clogged.
- Dishes don't dry3 causes in the manual. First: the inlet water is too cool.
- Spots and film on glasses and flatware3 causes in the manual. First: extremely hard water, or the rinse agent dispenser is empty.
- White film on glassware, dishes and the tubA low-quality phosphate-free detergent is the likely cause of a white film on glassware, dishware and the interior. Hard-water minerals also leave a white film on the tub interior.
- Glassware is cloudy and the cloudiness does not wash offEtching, which is permanent. It comes from soft water combined with too much detergent, or from inlet water above 150 °F.
- Suds in the tub2 causes in the manual. First: the wrong detergent was used. Detergent not made for dishwashers fills the dishwasher with suds.
- Detergent is left in the dispenser cupDishes or utensils block the detergent cup or stop its door from opening.
- Control panel lights go off while setting the controlsMore than 30 seconds passed between pad presses. The display also turns off when the door stays open for two minutes.
- Black or gray marks on dishesAluminum utensils rubbed against the dishes.
Sources
- Owner's Manual, Dishwashers GD*565-665, DD*700 and PD*715-785 Series. GE Appliances, a Haier company. Document 49-4000270, revision Rev 0, 2022-07, 78 pages, en-US. images.salsify.com (PDF). Listed on the manufacturer's support page. Retrieved 13 November 2026.
- Quick Specs, GDT645SFN/SGN/SMN/SSN/SYN Stainless Steel Interior Dishwasher with Hidden Controls. GE Appliances. Document GDT645SFN/SGN/SMN/SSN/SYN, revision Specification revised 6/20, 2020-06, 2 pages, en-US. images.salsify.com (PDF). Listed on the manufacturer's support page. Retrieved 13 November 2026.
Page numbers are the numbers printed in the manual. Where this page and the manual differ, follow the manual.