Bosch dishwasher reset
To end a cycle early or switch to a different one.
Steps
- Open the dishwasher door.
- Press the ON/OFF button for about 4 seconds.
- Close the door. The cycle is terminated and the dishwasher resets.
All LEDs light up for about 1 minute. When they go out, the display shows 00h:01m while the residual water is pumped out, and the cycle ends after about 1 minute.
Source: Basic operation: Terminating the wash cycle Source: Basic operation: Terminating the wash cycle, p. 30
Used for
- E:32-00: Water is not coming in.
Other SHP78CM5N procedures
- How to clean the drain pumpWhen water no longer drains properly, or E:61-02 or E:61-03 appears.
- How to clean the filtersCheck the filters for residue after each wash. Clean them when food is left on dishware or water is left in the appliance at the end of the program.
- How to clean the spray armsRegularly, and when food is left on dishware. Limescale and debris in the dishwashing water may block the nozzles and bearings.
- How to refill the rinse aidWhen the rinse aid refill indicator lights up. Use only rinse aid made for household dishwashers.
Sources
- Use and Care Manual, Dishwasher SHP78CM5N. BSH Home Appliances Corporation. Document 9001641455, revision C, 56 pages, en-US. media3.bsh-group.com (PDF). Listed on the manufacturer's support page. Retrieved 13 November 2026.
Page numbers are the numbers printed in the manual. Where this page and the manual differ, follow the manual.