Philips EP3241/54 how to lubricate the brew group
Every 2 months, and when the coffee is watery or the machine sounds different.
You need
- Philips grease
Steps
- Remove the brew group.
- Apply a thin layer of Philips grease to the grey piston.
- Apply a thin layer around the yellow shaft at the bottom.
- Apply a thin layer to the rails on both sides, then refit the brew group.
Source: Lubricating the brew group Source: Lubricating the brew group, p. 13
Used for
- Alarm light flashing: The brew group is missing, not seated correctly, or blocked.
- Coffee is watery
- Machine is unusually loud
Other EP3241/54 procedures
- How to descale with Calc / CleanWhen the Calc / Clean light flashes slowly. Takes about 30 minutes.
- How to install and activate an AquaClean filterAt first use, when the AquaClean light flashes orange (after 95 litres), and at least every 3 months.
- How to set the water hardnessAt first use; the default is 4 (hard water). The correct setting avoids descaling more often than needed.
- How to remove and insert the brew groupFor weekly cleaning, and when the alarm light flashes.
- How to clean the brew groupRinse weekly; use a coffee oil remover tablet monthly.
Sources
- User manual, Fully automatic espresso machine 800, 1200, 2200, 2300 and 3200 series (multilingual; English pp. 4–24). Versuni Holding B.V. Document 642001040436, revision 07/2026, 2026-07, 635 pages, en. dam.versuni.com (PDF). Retrieved 13 November 2026.
Page numbers are the numbers printed in the manual. Where this page and the manual differ, follow the manual.