Keurig K-Supreme Plus how to run a cleansing brew
At first setup, and twice after cleaning the entrance needles.
Steps
- Place a large mug (296 ml / 10 oz) on the drip tray.
- Lift and lower the handle without inserting a K-Cup pod. The coffee maker powers on automatically.
NOTICE
Do not remove the water reservoir after the BREW button has been pressed until the brew has completed.
Signal word assigned by Model Handbook Source: Before You Brew: Cleansing Brew, p. 2
- Press the 8oz button, then press the blinking BREW button.
- Pour the hot water into the sink when the brew is complete.
Source: Before You Brew: Cleansing Brew Source: Before You Brew: Cleansing Brew, p. 2
Other K-Supreme Plus procedures
- How to descale the coffee makerWhen the DESCALE notification turns on, or every 3 months. Allow 15 to 20 minutes.
- How to clean the exit needle and K-Cup pod holderWhen grounds get into the coffee or the coffee maker brews a partial cup.
- How to clean the entrance needlesWhen grounds get into the coffee.
- How to purge the coffee makerWhen the coffee maker brews only a partial cup.
- How to turn on High Altitude Brewing ModeAt altitudes of 1,500 metres / 5,000 feet or higher.
Sources
- K-Supreme Plus Use & Care Guide. Keurig Green Mountain, Inc. Document DC0000005009, revision REV A, 6 pages, en-CA. dam.keurig.com (PDF). Retrieved 13 November 2026.
Page numbers are the numbers printed in the manual. Where this page and the manual differ, follow the manual.