De'Longhi ECAM370.95.T “ADD GROUND COFFEE MAX. ONE MEASURE”
Pre-ground coffee was selected but the funnel is empty, or a LONG coffee made with pre-ground coffee needs its second measure.
Cause 1 of 2Pre-ground function selected with no coffee in the funnel. Source: 18. Displayed messages, p. 19
First checkPut one level measure of pre-ground coffee in the funnel and start the drink again.
Causes and checks
Pre-ground function selected with no coffee in the funnel. Source: 18. Displayed messages, p. 19
- Put one level measure of pre-ground coffee in the funnel and start the drink again.
Halfway through a LONG coffee made with pre-ground coffee. Source: 18. Displayed messages, p. 20
- Add one level measure of pre-ground coffee and press OK to finish the drink.
All 2 causes checked. Contact De'Longhi Customer Services.
Service
If the checks above do not clear it, contact De'Longhi Customer Services, delonghi.com/en/s/ECAM370.95.T. Numbers per country are on the Customer Service sheet supplied with the machine. Source: 1.2 Troubleshooting and repairs, p. 7
Other ECAM370.95.T codes
- FILL TANK WITH FRESH WATER: There is not enough water in the tank.
- INSERT WATER TANK: The water tank is not correctly in place.
- EMPTY GROUNDS CONTAINER: The grounds container is full, or 72 hours have passed since the first coffee after it was last emptied. No coffee can be made until it is emptied.
- INSERT GROUNDS CONTAINER: The grounds container was not refitted after cleaning.
- FILL BEANS CONTAINER: The beans have run out, or the pre-ground coffee funnel is clogged.
- GROUND TOO FINE. ADJUST MILL: Coffee comes out too slowly or not at all because the grind is too fine, or an air bubble from the water filter is blocking delivery.
- SELECT A MILDER TASTE OR REDUCE COFFEE AMOUNT: Too much coffee was used.
- INSERT WATER SPOUT: The hot water spout is missing or not fitted correctly.
- INSERT MILK CONTAINER: The milk container is not fitted correctly.
- INSERT INFUSER ASSEMBLY: The infuser (brew unit) was not refitted after cleaning.
- WATER CIRCUIT EMPTY PRESS OK TO START: The water circuit is empty.
- PRESS OK TO CLEAN OR TURN DIAL: The milk container was fitted with its froth dial at CLEAN.
- TURN MILK FROTH ADJUSTMENT DIAL TO CLEAN POSITION: Milk was made recently and the milk container tubes need their after-use clean.
- TURN FROTH ADJUSTMENT DIAL: A milk drink was selected while the froth dial is at CLEAN.
- DESCALING NEEDED PRESS OK TO START (~45MIN): The machine needs descaling. Press OK to start now, or ESC to postpone; the descale symbol then stays on the homepage and the message returns at every switch-on.
- REPLACE WATER FILTER PRESS OK TO START: The water softener filter is used up.
- GENERAL ALARM: REFER TO USER MANUAL / APP: The inside of the machine is very dirty.
- Milk container cleaning symbol: The tubes inside the milk container need cleaning.
- Filter symbol: Reminder that the water softener filter must be replaced.
- Descale symbol: The machine must be descaled. Requests at very short intervals are normal for this machine's control system.
- Energy saving symbol: Energy saving is switched on; drinks may take a few seconds longer to start.
- CLEANING UNDERWAY PLEASE WAIT: The machine found impurities in its internal circuits and is cleaning them; it will not make coffee meanwhile.
Sources
- Instructions for use, Dinamica Plus ECAM370.95.T (English). De'Longhi Appliances S.r.l. Document 5713238071, revision EN-5713238071 (PDF dated 2018-07-06), 2018-07-06, 25 pages, en. library.delonghigroup.com. Listed on the manufacturer's support page. Retrieved 13 November 2026.
Page numbers are the numbers printed in the manual. Where this page and the manual differ, follow the manual.