NETGEAR RAX50 how to set up the router as a WiFi access point

When you want this router to add WiFi to a network that another router manages.

Steps

  1. Connect the Internet port of this router to an Ethernet port on the other router with an Ethernet cable.
  2. Log in at http://www.routerlogin.net and select ADVANCED > Advanced Setup > Router / AP Mode.
  3. Select AP Mode.
  4. Select Get dynamically from existing router so the other router assigns this router's IP address.
  5. Click the Apply button. The router's IP address changes and you are disconnected.
  6. Close and restart your browser and open http://www.routerlogin.net to log in again.

Use different WiFi settings on each router to avoid interference, or turn off the WiFi radio on the other router.

Source: Manage Network Settings, Set up the router as a WiFi access point Source: Manage Network Settings, Set up the router as a WiFi access point, pp. 74, 75

Other RAX50 procedures

Sources

  1. User Manual, Nighthawk AX6 6-Stream AX5400 WiFi Router RAX50 and RAX50v2. NETGEAR, Inc. Document 202-12630-02, revision January 2023, 2023-01, 160 pages, en-US. downloads.netgear.com (PDF). Listed on the manufacturer's support page. Retrieved 13 November 2026.

Page numbers are the numbers printed in the manual. Where this page and the manual differ, follow the manual.

Applies to
RAX50 (variant RAX50v2, hardware v2). United States.
Source
User Manual, Nighthawk AX6 6-Stream AX5400 WiFi Router RAX50 and RAX50v2, 202-12630-02 revision January 2023, 2023-01
Last verified
Handbook
NETGEAR Nighthawk AX6 RAX50 AX5400 WiFi 6 router in Routers; all NETGEAR handbooks