Samsung WA49B5205AW error 4C
Water is not being supplied. The washer drains for 3 minutes while the code shows, and the Power button does not respond during that time.
Cause 1 of 3The water supply is closed, restricted or too weak. Source: Troubleshooting: Information codes, p. 57
First checkMake sure the water taps are open.
Causes and checks
The water supply is closed, restricted or too weak. Source: Troubleshooting: Information codes, p. 57
- Make sure the water taps are open.
- Make sure the water hoses are not clogged or kinked.
- Make sure the water taps are not frozen.
- Make sure the washing machine is operating with sufficient water pressure.
The cold and hot water hoses are on the wrong taps. Source: Troubleshooting: Information codes, p. 57
- Make sure that the cold water tap and the hot water tap are properly connected.
A mesh filter is clogged. Source: Troubleshooting: Information codes; Maintenance: Cleaning the mesh filter, pp. 57, 49
- Clean the mesh filters in the water inlets. See Clean the mesh filters in the water inlets.
All 3 causes checked. Contact Samsung Customer Service: 1-800-SAMSUNG (726-7864).
Service
If the checks above do not clear it, contact Samsung Customer Service: 1-800-SAMSUNG (726-7864), samsung.com/us/support/. United States. Source: Troubleshooting: Information codes, p. 60
Other WA49B5205AW codes
- 1C: The water level sensor is not working properly. The washer drains automatically for 3 minutes, and the Power button does not respond during that time.
- 3C: The motor needs checking.
- 4C2: The cold water supply hose may be on the hot water tap.
- 5C: Water is not draining.
- 9C1: The electronic control needs to be checked (over-voltage error).
- 9C2: Low voltage was detected.
- AC6: The inverter is reporting a communication problem.
- dC: The washer is operating with the door open.
- HC: High temperature heating check.
- LC: The drain hose needs checking. The washer drains for 3 minutes while the code shows, and the Power button does not respond during that time.
- OC: Water overflowed.
- PC: The position of the clutch cannot be detected.
- PC1: The clutch hall signal is incorrect after the clutch position was detected.
- Ub: Spinning does not work.
- Ur: The washer added a rinse because the tub was unbalanced.
- 8C: The MEMS sensor needs checking.
- dn: A firmware update is in progress through SmartThings.
Sources
- User manual, Washer WA49B5205A*. Samsung Electronics America, Inc. Document DC68-04037Q-05, revision 05, 72 pages, en. downloadcenter.samsung.com (PDF). Listed on the manufacturer's support page. Retrieved 13 November 2026.
Page numbers are the numbers printed in the manual. Where this page and the manual differ, follow the manual.