Dreame l10s ultra not charging
Cause 1 of 3The base station is not connected to power. Source: FAQ, p. 23
First checkMake sure both ends of the base station power cord are correctly plugged in.
Causes and checks
The base station is not connected to power. Source: FAQ, p. 23
- Make sure both ends of the base station power cord are correctly plugged in.
The contact between the charging contacts on the base station and the robot is poor. Source: FAQ, p. 23
- Clean the charging contacts. See Clean the sensors, charging contacts and vents.
There may be a foreign object at the connector of the robot. Source: FAQ, p. 23
- Check whether there is any foreign object at the connector of the robot and remove it.
All 3 causes checked. Contact Dreame support.
Service
If the checks above do not clear it, contact Dreame support, global.dreametech.com. Worldwide. Source: FAQ, p. 25
Other L10s Ultra problems
- The robot will not turn on2 causes in the manual. First: the battery is low.
- The robot fails to connect to Wi-Fi5 causes in the manual. First: the Wi-Fi network password is incorrect.
- The robot cannot find and return to the base station4 causes in the manual. First: the base station is disconnected from power or was moved when the robot was not on it.
- The robot gets stuck in front of the base station3 causes in the manual. First: obstructions stand within 0.5 m on the left and right sides or within 1.5 m in front of the base station.
- The robot will not turn off2 causes in the manual. First: the robot cannot be turned off when it is charging.
- The charging speed is slow3 causes in the manual. First: A low battery takes about 6 hours to charge fully.
- The noise increases while the robot is operating4 causes in the manual. First: the dust bin filter is clogged.
- The robot moves without following the set route3 causes in the manual. First: objects such as power cords and slippers are in the way.
- The robot misses rooms to be cleaned3 causes in the manual. First: A room door is closed.
- The robot will not resume cleaning after chargingDo Not Disturb (DND) mode prevents the robot from resuming cleaning.
- The robot does not respond to the base station buttonsThe robot may be out of the base station's wireless range.
- The station does not empty the dust bin automatically3 causes in the manual. First: the dust collection bag in the dust cabinet is full.
- The water level in the washboard is abnormal5 causes in the manual. First: the seal on the used water tank is loose or not correctly installed.
Sources
- User Manual, Dreame L10s Ultra (R2228, EN/DE/FR/IT/ES/RU/PL/HE/AR/NL). Dreame Trading (Tianjin) Co., Ltd. Document R2228, revision A09, 109 pages, en. global.dreametech.com. Listed on the manufacturer's support page. Retrieved 13 November 2026.
Page numbers are the numbers printed in the manual. Where this page and the manual differ, follow the manual.