Samsung DW80R5060US how to switch AutoRelease Dry on or off
To change whether the door opens at the end of the cycle to improve drying. A1 turns it on and A0 turns it off; A1 is the default and gives better drying results.
Steps
- With the dishwasher on, press Delay Start and Sanitize together for 3 seconds to enter Setting mode.
- Press the Sanitize button until A1 or A0 is displayed.
- Press the Delay Start button to apply your choice.
Alternatively, press Lower Rack and Hi-Temp Wash together for 3 seconds to enable or disable AutoRelease Dry. AutoRelease Dry is disabled for the Rinse only cycle.
Source: Using your dishwasher: Auto Release Source: Using your dishwasher: Auto Release, p. 12
Used for
Other DW80R5060US procedures
- How to clean the lower nozzleWhen the dishwasher does not seem to clean adequately or the nozzles seem clogged. Take care when removing nozzles, as they may break.
- How to clean the middle nozzleWhen the dishwasher does not seem to clean adequately or the nozzles seem clogged. Take care when removing nozzles, as they may break.
- How to clean the upper nozzleWhen the dishwasher does not seem to clean adequately or the nozzles seem clogged. Take care when removing nozzles, as they may break.
- How to clean the dishwasher interiorPeriodically, to remove dirt or food particles.
- How to remove white spots and odor with vinegarWhen white spots and odor remain after cleaning the interior.
Sources
- User manual, Dishwasher DW80K7050, DW80K5050, DW80R5060, DW80R5061 and DW80T5040 series. Samsung Electronics America, Inc. Document DD81-02025D-01, revision 01, 114 pages, en. downloadcenter.samsung.com (PDF). Listed on the manufacturer's support page. Retrieved 13 November 2026.
Page numbers are the numbers printed in the manual. Where this page and the manual differ, follow the manual.